Shakespeare Electronic Marine Instruments 408 R User Manual

Style 408-R  
Thank you for purchasing a Shakespeare antenna product.  
Customer comments are welcome. Before installing, please study  
the diagram and check parts supplied against those listed.  
Supplied Parts  
1 Standoff Bracket assembly  
1 1” Reducing adapter  
IMPORTANT! Please read all instructions before installing.  
1
8
1 1/ Reducing adapter  
The Style 408-R Standoff Bracket is a support and insulator  
bracket for use with 1½” antennas, and for antennas of 11/8” and 1”  
diameter by using the appropriate adapter (supplied).  
Wing Nut  
Tools required: Drill and drill bit for ¼” screws;  
screwdriver; wrench or pliers  
Retainer Bar  
Installation Instructions  
Antenna  
Reducing  
Adapter  
Choose an antenna mounting location that is as high as feasible,  
as free as possible from obstructions, and as far as possible from  
other antennas and strong sources of RF.  
Standoff  
Bracket  
Assembly  
1. Loosen the wing nut on top of the Standoff Bracket and slide  
the retainer bar out of the way. Gently place the antenna in  
its mounting position in the U-shaped opening in the bracket.  
For 11/8” and 1” antennas, put the appropriate reducing adapter  
(supplied) in the opening.  
Mounting  
Screw*  
2. Rotate the retainer bar over the antenna to lock it in place.  
3. Using the Standoff Bracket itself as a template, mark the  
position for its mounting holes.  
4. Drill ¼” mounting holes, and install the bracket using stainless  
steel machine screws, washers, lockwashers, and nuts (hardware  
sold separately). For mounting to some types of surfaces, you  
might need to substitute stainless steel woodscrews or other  
hardware (not supplied).  
Washer*  
IMPORTANT: If the thickness of the mounting  
surface is not adequate to support the antenna under  
expected stress, a wooden back-up pad (not supplied)  
should be applied underneath the mounting surface  
during installation.  
Lockwasher*  
Nut*  
* Not supplied. For some types of mounting  
surfaces you might need stainless steel  
woodscrews or other hardware.  
5. Tighten the wing nut to secure the antenna in the bracket. The  
completed installation should attach the antenna firmly to the  
mounting surface, leaving no “play” between the antenna and  
the standoff bracket.  
Shakespeare Electronic Products Group  
Shakespeare is a subsidiary of Jarden Corporation (NYSE: JAH)  
©2002 Shakespeare Co.  
· Form I-408-R J: rev. 04/25/2010  
 

Sharp Flat Panel Television LL 171MU User Manual
Sierra Monitor Corporation Air Cleaner IZS31 User Manual
Singer Sewing Machine 147 1 User Manual
Soleus Air Electric Heater HC6 15R 01 User Manual
Sony CRT Television KV HA14 User Manual
SOYO Computer Hardware SY 7VCA2 User Manual
Stanley Black Decker Saw RS25 User Manual
StarTechcom Switch Sv231 User Manual
Tanaka Chainsaw TCS 3401 User Manual
Tanita Scale BC 548 User Manual